×

Monster Gardens Monster Gardens's hydroponic grow store industry providers offer the grow market’s best products at wholesale prices with customer service and FREE SHIPPING!
235 Classic Ct Suite B Rohnert Park, CA 94928, USA
Monster Gardens Phone: (707) 588-8844

(707) 588-8844   SALES & SUPPORT MON-FRI. 9:30AM-5:30PM PST  

Selection will refresh the page with new results

Hanna GroLine Cleaning Solution (HI7061-050), 500ml

In stock
SKU
h_mt_123
Special Price $15.40 Regular Price $23.00
HI7061-050 is the GroLine general purpose cleaning solution that can be used for a variety of applications. Electrodes can become dirty from use and will produce inaccurate results even as they read correctly in a pH buffer. Hanna's cleaning solutions eliminate impurities and residues that are left on electrode surfaces when immersed in samples during measurement or when stored incorrectly.

Hanna GroLine Cleaning Solution (HI7061-050), 500ml

HI7061-050 is the GroLine general purpose cleaning solution that can be used for a variety of applications. Electrodes can become dirty from use and will produce inaccurate results even as they read correctly in a pH buffer. Hanna's cleaning solutions eliminate impurities and residues that are left on electrode surfaces when immersed in samples during measurement or when stored incorrectly.

Hanna suggests cleaning the bulb and junction of your electrode on a regular basis to ensure that the probe is always clean and to prevent any clogging of the junction. The HI7061-050 is for 500 mL of general purpose cleaning solution.

The most common cause for pH measurement inaccuracies is an unclean or improperly cleaned electrode. This is very important to note, because during calibration, the instrument assumes that the electrode is clean and that the standardization curve created during the calibration process will remain a valid reference until the next calibration. pH meters on the market today will allow an offset voltage of approximately ±60 mV. The deviation from 0 mV is not unusual but ideally should be no greater than ±30 mV. The calibration process compensates for the change in offset voltage. If the mV offset continues to deviate and the meter is calibrated with a dirty electrode then inaccurate readings will result.



Cleaning is a fast and effective routine that should be performed on a regular basis as a preventative measure against using a dirty electrode and to ensure that the junction is not clogged. By simply immersing the electrode in the HI7061-050 cleaning solution for 15 to 20 minutes will dissolve any mineral deposits or other coatings.

Features:
  • Specially formulated for cleaning electrodes
  • Air tight bottle with tamper-proof seal: ensures quality and freshness of solution
  • Each bottle marked with lot number and expiration date: Hanna cleaning solutions are specially formulated to have an expiration of 5 years from manufacture for an unopened bottle
More Information
SKU h_mt_123
UPC 0