Uvonair CD Inline Duct Ozonator 10 in - 2 Cell

Out of stock

SKU

ff_af_202

$435.00

The Uvonair CD-1000-2 Two Cell In-Duct Ozone Model is a high output Corona Discharge generator that produces more ozone than any others known at this time. It is adjustable to match the ozone demand load for odor control as well as provide energy conservation in low demand periods The CD generator does not require servicing.

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Details
More Information

Uvonair CD Inline Duct Ozonator 10 in - 2 Cell

Features:

Ideal for rooms from 20,000 cu.ft (600 m3) up to 40,000 cu.ft. (1200 m3)
Installs into 10 inch (25 cm) ducts to treat the air as it is being exhausted
Adjustable (HIGH/LOW/OFF) switch
Can be installed into other size ducts using adapters* (however, larger ducts may comprimise airflow). Uvonair CD models are recommended in larger ducts and high odor situations
Works in areas with high humidity
Works in a wide range of temperatures
Environmentally friendly creating no hazardous waste!
Full one year warranty
No maintenance required
Over 20 years proven & tested!
Approved to UL safety standards!
*Adapters not included; use with ventilation system

Installation:

Position the Uvonair CD In-Duct Odor Eliminator generator, where possible, a minimum of 15 ft. (5 m) from the end of the exhaust duct to ensure adequate reaction time with odors. We A minimum of 15 ft. (5m) of ductwork is recommended.
When using a fan, always put the ozonator on the output side of the fan.
Requires 110V 60Hz electrical power.
Install in accordance to local electrical standards.
As a safety feature, the Uvonair® CD unit must be working in tandem with the ventilation exhaust fan.
Follow manufacturers’ instructions regarding synchronizing with the ventilation fan.
Uvonair CD is equipped with a 6 ft (2m) cord with a grounded three-prong plug and a surge protection fuse.
Contact qualified personnel to install the proper outlet.
Do not alter the plug in any way.
Use caution to keep all electrical connections dry.

Operation Directions:

Consult a ventilation professional for specific duct lengths as this may vary depending on the existing duct setup and its ability to adjust for the insertion of the Uvonair UV In-Duct system.
The weight of the unit must be supported with duct-hanging wire from the support bracket to a hook or nail on the joists above. Make final adjustment after final installation.
Insert the unit into the existing ducts up to mounting ridges making it airtight using duct tape or clamps.
Disconnect power to the unit prior to servicing.

Note:

The Uvonair CD In-Duct system should be located so that a connection can be made to the electrical source without the use of an extension cord. No maintenance is required of these units. NOT serviceable by user, for any maintenance issues please contact your local dealer.